DTC P0340 Camshaft Position Sensor "A" Circuit (Bank 1 or Single Sensor) |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0340 | Either condition is met:
|
|

| Item | Contents |
| ECM Terminal Name | CH1: G2 - NE- CH2: NE+ - NE- |
| Tester Range | 5 V/DIV., 20 ms./DIV. |
| Condition | Cranking or idling |
| 1.INSPECT CAMSHAFT POSITION SENSOR (RESISTANCE) |
Inspect the camshaft position sensor (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CAMSHAFT POSITION SENSOR - ECM) |
Disconnect the camshaft position sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C1-1 - E21-11 (G2) | Always | Below 1 Ω |
| C1-2 - E21-5 (NE-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| C1-1 or E21-11 (G2) - Body ground | Always | 10 kΩ or higher |
| C1-2 or E21-5 (NE-) - Body ground | Always | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the camshaft position sensor connector.
|
| ||||
| OK | |
| 3.CHECK SENSOR INSTALLATION (CAMSHAFT POSITION SENSOR) |
![]() |
Check the camshaft position sensor installation condition.
|
| ||||
| OK | |
| 4.CHECK VALVE TIMING |
Check the valve timing.
|
| ||||
| OK | |
| 5.INSPECT CAMSHAFT |
Check the teeth of the camshaft.
|
| ||||
| OK | |
| 6.REPLACE CAMSHAFT POSITION SENSOR |
Replace the camshaft position sensor (Click here).
| NEXT | |
| 7.CHECK WHETHER DTC OUTPUT RECURS (DTC P0340) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Clear DTCs (Click here).
Start the engine.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P0340 is output | B |
|
| ||||
| A | ||
| ||