Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › CONDENSER (for 2TR-FE)

CONDENSER (for 2TR-FE) > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start the engine.

  1. Operate the cooler compressor under the conditions shown below:
    Item
    Condition
    Engine Speed
    Idling
    Operating Time
    3 minutes or more
    A/C Switch Status
    On
    Blower Switch Status
    HI
    Set Temperature
    MAX COOL
    This causes most of the compressor oil from the various components of the A/C system to collect in the A/C compressor.

    NOTICE:
    It is not necessary to operate the cooler compressor if the A/C does not operate because of compressor lock, etc.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

    HINT:
    Use the refrigerant recovery unit in accordance with the manufacturer's instruction manual.



2. REMOVE FRONT BUMPER COVER
(Click here)


3. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


E225069
  1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the cooler condenser.

  1. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



4. DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY


E225070
  1. Remove the bolt and disconnect the air conditioning tube and accessory assembly from the cooler condenser.

  1. Remove the O-ring from the air conditioning tube and accessory assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



5. REMOVE HOOD LOCK ASSEMBLY


    B280284
  1. Remove the 3 bolts.



    B280285
  1. Disconnect the hood lock control cable and remove the hood lock.

  1. Disconnect the hood lock control cable and remove the hood lock assembly.



6. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY


E233831
  1. Remove the 7 bolts and upper radiator support sub-assembly.



7. REMOVE COOLER CONDENSER ASSEMBLY


E228615
  1. Remove the cooler condenser assembly.