DTC P0818 Driveline Disconnect Switch Input Circuit |
| DTC No. | DTC Detection Conditions | Trouble Area |
| P0818 | The No. 2 transfer indicator switch remains on while the vehicle is running under the following conditions for 30 seconds. (2-trip detection logic):
|
|

| 1.CHECK HARNESS AND CONNECTOR (NO. 2 TRANSFER INDICATOR SWITCH - BODY GROUND) |
![]() |
Disconnect the No. 2 transfer indicator switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T6-2 - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to No. 2 Transfer Indicator Switch) |
|
| ||||
| OK | |
| 2.INSPECT NO. 2 TRANSFER INDICATOR SWITCH |
![]() |
Remove the No. 2 transfer indicator switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Not pushed | 10 kΩ or higher |
| 1 - 2 | Pushed | Below 1 Ω |
| *a | Component without harness connected (No. 2 Transfer Indicator Switch) |
| *b | Pushed |
| *c | Not pushed |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (NO. 2 TRANSFER INDICATOR SWITCH - TCM) |
Disconnect the T6 No. 2 transfer indicator switch connector.
Disconnect the T36 TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T6-1 - T36-16 (TFN) | Always | Below 1 Ω |
| T6-1 or T36-16 (TFN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||