Home › TRANSMISSION · A750F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV without i-ART)

DTC    P0818    Driveline Disconnect Switch Input Circuit

for Preparation Click here


DESCRIPTION

The TCM detects the signal from the No. 2 transfer indicator switch (the transfer neutral position switch).
This DTC indicates that the No. 2 transfer indicator switch remains on.

DTC No.
DTC Detection Conditions
Trouble Area
P0818
The No. 2 transfer indicator switch remains on while the vehicle is being driven under the following conditions for 30 seconds (2-trip detection logic):
  1. Vehicle speed is 25.1 km/h (15.6 mph) or more.
  2. Transfer shift lever position: H.
  1. Short in No. 2 transfer indicator switch (the transfer neutral position switch) circuit
  2. No. 2 transfer indicator switch
  3. TCM

MONITOR DESCRIPTION

The TCM detects whether or not the transfer shift lever is in neutral by monitoring the signal from the No. 2 transfer indicator switch.
If the TCM detects that the transfer shift lever is in neutral under the following conditions, the TCM will conclude that there is a malfunction of the No. 2 transfer indicator switch:
  1. No. 2 transfer indicator switch indicates that the transfer shift lever is in neutral.
  2. Transfer shift lever is in the H position.
  3. The vehicle is traveling at 25.1 km/h (15.6 mph) or more.
  4. The No. 2 transfer indicator switch has been on for more than 30 seconds.
If all of the above conditions are detected, the TCM will conclude that there is a malfunction of the No. 2 transfer indicator switch, illuminate the MIL and store the DTC.

WIRING DIAGRAM


C154998E49


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NO. 2 TRANSFER INDICATOR SWITCH - BODY GROUND)


    C237850E09
  1. Disconnect the No. 2 transfer indicator switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T6-2 - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to No. 2 Transfer Indicator Switch)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT NO. 2 TRANSFER INDICATOR SWITCH
C237864E01
  1. Remove the No. 2 transfer indicator switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    1 - 2
    Pushed
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (No. 2 Transfer Indicator Switch)
    *b
    Pushed
    *c
    Not pushed



NG
REPLACE NO. 2 TRANSFER INDICATOR SWITCH
OK


3.CHECK HARNESS AND CONNECTOR (NO. 2 TRANSFER INDICATOR SWITCH - TCM)
  1. Disconnect the T6 No. 2 transfer indicator switch connector.

  1. Disconnect the T36 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T6-1 - T36-16 (TFN)
    Always
    Below 1 Ω
    T6-1 or T36-16 (TFN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TCM