DTC P0340 Camshaft Position Sensor "A" Circuit (Bank 1 or Single Sensor) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0340 | When either condition below is met:
|
|
| 1.INSPECT CAMSHAFT POSITION SENSOR (RESISTANCE) |
Inspect the camshaft position sensor (Click here).
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (CAMSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the C1 sensor connector.
Disconnect the E6 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| C1-1 - E6-23 (G+) | Below 1 Ω |
| C1-2 - E6-31 (G-) | Below 1 Ω |
| C1-1 or E6-23 (G+) - Body ground | 10 kΩ or higher |
| C1-2 or E6-31 (G-) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK CAMSHAFT POSITION SENSOR (INSTALLATION) |
![]() |
Check the sensor installation.
|
| ||||
| OK | |
| 4.CHECK PUMP DRIVE SHAFT PULLEY |
Check the teeth of the pump drive shaft pulley.
|
| ||||
| OK | ||
| ||