DTC P0180 Fuel Temperature Sensor "A" Circuit |
DTC P0182 Fuel Temperature Sensor "A" Circuit Low Input |
DTC P0183 Fuel Temperature Sensor "A" Circuit High Input |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0180 | Open or short in fuel temperature sensor circuit for 0.5 seconds (1 trip detection logic) |
|
| P0182 | Short in fuel temperature sensor circuit for 0.5 seconds (1 trip detection logic) |
|
| P0183 | Open in fuel temperature sensor circuit for 0.5 seconds (1 trip detection logic) |
|
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 140°C (284°F) or more | Short circuit |

| 1.CHECK ECM (THF VOLTAGE) |
![]() |
Start the engine.
Measure the voltage of the ECM connector.
| Tester Connection | Condition | Specified Condition |
| E7-29 (THF) - E7-28 (E2) | Idling, intake air temperature at 20°C (68°F) | 0.5 to 3.4 V |
|
| ||||
| NG | |
| 2.INSPECT FUEL TEMPERATURE SENSOR |
![]() |
Remove the sensor.
Measure the resistance of the sensor.
| Condition | Specified Condition |
| Approximately 20°C (68°F) | 2.32 to 2.59 kΩ |
| Approximately 80°C (176°F) | 0.310 to 0.326 kΩ |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (ECM - FUEL TEMPERATURE SENSOR) |
![]() |
Disconnect the ECM connector.
Disconnect the sensor connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E7-29 (THF) - F10-2 | Below 1 Ω |
| E7-28 (E2) - F10-1 | Below 1 Ω |
| E7-29 (THF) or F10-2 - Body ground | 10 kΩ or higher |
| E7-28 (E2) or F10-1 - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| E7-29 (THF) - F35-2 | Below 1 Ω |
| E7-28 (E2) - F35-1 | Below 1 Ω |
| E7-29 (THF) or F35-2 - Body ground | 10 kΩ or higher |
| E7-28 (E2) or F35-1 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||