ECD SYSTEM (for i-ART) > REGISTRATION |
| 1. LEARNING VALUES CONFIRMATION |

![]() |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Utility / Learning values confirmation.
![]() |
Press "Next".
![]() |
Press "Next" again to proceed.
![]() |
Select the value to confirm and press "Next".
![]() |
When the next screen is displayed, confirm the contents and press "Exit".
| 2. LEARNING VALUES SAVE |

![]() |
![]() |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Utility / Learning values save.
![]() |
Press "Next".
![]() |
Press "Next" again to proceed.
![]() |
Select any components being replaced and press "Next". If no applicable components are displayed, press "Next" without selecting anything.
![]() |
If the overwrite confirmation screen is displayed, press "Overwrite".
![]() |
When the operation is finished, confirm the date and time of the save operation, and press "Exit".
| 3. LEARNING VALUES WRITE |

![]() |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Utility / Learning values write.
![]() |
Press "Next".
![]() |
Press "Next" again to proceed.
![]() |
If the "Error Learning Values Write" screen indicating a problem with the saved value(s) or that there are no saved values is displayed, perform "Learning Values Save" again.
![]() |
Confirm the date and time of the save operation, and then press "Yes".
![]() |
Confirm the contents, and then press "Next".
If any instructions are displayed on the GTS, manually perform the procedure to register each applicable compensation code or learning value in the ECM.
Clear the DTCs.