DTC U0100/A2 Lost Communication with ECM/PCM "A" |
| DTC No. | DTC Detection Condition | Trouble Area |
| U0100/A2 | No communication from ECM continues (1 trip detection logic) |
|

| 1.CHECK ECM (VC, +B VOLTAGE, E1 GROUND) |
![]() |
Measure the voltage and resistance of the ECM connectors.
| Tester Connection | Switch Condition | Specified Condition |
| E4-1 (+B) - Body ground | Ignition switch ON | 9 to 14 V |
| E7-18 (VC) - Body ground | Ignition switch ON | 4.5 to 5.5 V |
| Tester Connection | Condition | Specified Condition |
| E6-7 (E1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK TCM (IG2 VOLTAGE, E1 GROUND) |
![]() |
Measure the voltage and resistance of the TCM connectors.
| Tester Connection | Switch Condition | Specified Condition |
| T35-6 (IG2) - Body ground | Ignition switch ON | 9 to 14 V |
| Tester Connection | Condition | Specified Condition |
| T19-1 (E1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (ECM - TCM) |
![]() |
Disconnect the E5 ECM connector.
Disconnect the T35 TCM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Condition | Specified Condition |
| E5-22 (CAN+) - T35-21 (CAN+) | Always | Below 1 Ω |
| E5-21 (CAN-) - T35-20 (CAN-) | Always | Below 1 Ω |
| E5-22 (CAN+) or T35-21 (CAN+) - Body ground | Always | 10 kΩ or higher |
| E5-21 (CAN-) or T35-20 (CAN-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CONFIRM DTC |
Clear the DTC.
Replace the TCM.
Start the engine.
Read the DTCs.
| Result | Proceed to |
| U0100/A2 is output | A |
| U0100/A2 is not output | B |
|
| ||||
| A | ||
| ||