Home › TRANSMISSION · A750F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV without i-ART)

DTC    P2772    Four Wheel Drive (4WD) Low Switch Circuit Range / Performance

for Preparation Click here


DESCRIPTION

The TCM detects the signal from the No. 1 transfer indicator switch (the transfer L4 position switch).
This DTC indicates that the No. 1 transfer indicator switch remains on.

DTC No.
DTC Detection Conditions
Trouble Area
P2772
The No. 1 transfer indicator switch remains on while the vehicle is being driven under the following conditions for 1.8 seconds or more (1 trip detection logic):
  1. Output shaft speed is between 750 and 3000 rpm.
  2. Transfer shift lever position is in H.
  1. Short in No. 1 transfer indicator switch (the transfer L4 position switch) circuit
  2. No. 1 transfer indicator switch
  3. TCM

MONITOR DESCRIPTION

The TCM monitors the No. 1 transfer indicator switch to determine when the transfer-case L4 gear is engaged. If the transfer-case L4 gears remain engaged under all of the following conditions, the TCM will conclude that there is a malfunction of the No. 1 transfer indicator switch:
  1. The No. 1 transfer indicator switch indicates that the L4 transfer-case gears are engaged.
  2. Transfer-case shift lever is in the "H" position.
  3. Transfer-case output shaft rpm is between 750 and 3000 rpm.
  4. The specified time period has elapsed.
Then the TCM will illuminate the MIL and store the DTC.

WIRING DIAGRAM


C175018E21


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NO. 1 TRANSFER INDICATOR SWITCH - BODY GROUND)


    C237849E08
  1. Disconnect the No. 1 transfer indicator switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T5-2 - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to No. 1 Transfer Indicator Switch)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT NO. 1 TRANSFER INDICATOR SWITCH


    C237865E01
  1. Remove the No. 1 transfer indicator switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    1 - 2
    Pushed
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (No. 1 Transfer Indicator Switch)
    *b
    Pushed
    *c
    Not pushed



NG
REPLACE NO. 1 TRANSFER INDICATOR SWITCH
OK


3.CHECK HARNESS AND CONNECTOR (NO. 1 TRANSFER INDICATOR SWITCH - TCM)
  1. Disconnect the T5 No. 1 transfer indicator switch connector.

  1. Disconnect the T36 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T5-1 - T36-15 (L4)
    Always
    Below 1 Ω
    T5-1 or T36-15 (L4) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TCM