DTC P0037 Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) |
DTC P0038 Oxygen Sensor Heater Control Circuit High (Bank 1 Sensor 2) |
DTC P0141 Oxygen Sensor Heater Circuit Malfunction (Bank 1 Sensor 2) |


| DTC No. | DTC Detection Condition | Trouble Area |
| P0037 | Heater current is 0.3 A or less when heater operates (1 trip detection logic) |
|
| P0038 | Heater current exceeds 2 A when heater operates (1 trip detection logic) |
|

| 1.INSPECT HEATED OXYGEN SENSOR (HEATER RESISTANCE) |
![]() |
Disconnect the H5 sensor connector.
Measure the resistance of the heated oxygen sensor.
| Tester Connection | Condition | Specified Condition |
| 1 (HT1B) - 2 (+B) | 20°C (68°F) | 11 to 16 Ω |
| 1 (HT1B) - 4 (E2) | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT INTEGRATION NO.1 RELAY (MAIN RELAY) |
![]() |
Remove the integration relay from the engine room junction block.
Measure the voltage of the MAIN relay.
| Tester Connection | Condition | Specified Condition |
| 1J-5 - Body ground | Ignition switch ON | 10 to 14 V |
|
| ||||
| OK | |
| 3.INSPECT ECM (HT1B VOLTAGE) |
![]() |
Turn the ignition switch ON.
Measure the voltage of the E11 ECM connector.
| Tester Connection | Specified Condition |
| E11-2 (HT1B) - E11-3 (E1) | 9 to 14 V |
|
| ||||
| NG | |
| 4.CHECK WIRE HARNESS (HEATED OXYGEN SENSOR - INTEGRATION RELAY (MAIN RELAY), ECM) |
![]() |
Disconnect the H5 sensor connector.
Disconnect the E11 ECM connector.
Remove the integration relay from the engine room junction block.
Disconnect the 1J integration relay connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| H5-1 (HT1B) - E11-2 (HT1B) | Below 1 Ω |
| H5-2 (+B) - 1J-5 | Below 1 Ω |
| H5-1 (HT1B) or E11-2 (HT1B) - Body ground | 10 kΩ or higher |
| H5-2 (+B) or 1J-5 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||