Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM (w/ Secondary Air Injection System)

DTC    P0617    Starter Relay Circuit High

for Preparation Click here


DESCRIPTION

While the engine is being cranked, positive (+) battery voltage is applied to terminal STA of the ECM. If the vehicle is being driven and the ECM detects the starter control signal (STA), the ECM concludes that the starter control circuit is malfunctioning. The ECM will illuminate the MIL and set a DTC.

DTC No.
DTC Detection Condition
Trouble Area
P0617
When conditions (a), (b) and (c) are met and battery (+B) voltage of 10.5 V or more is applied for 20 seconds.
(a) Vehicle speed is greater than 20 km/h (12 mph)
(b) Engine revolution is greater than 1,000 rpm
(c) STA signal ON
  1. Park/neutral position switch assembly
  2. Short in STA signal circuit
  3. Ignition switch
  4. ECM

WIRING DIAGRAM


A296813E01


INSPECTION PROCEDURE

HINT:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1.READ DATA LIST (STARTER SIGNAL)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the intelligent tester ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / Starter Signal.

  1. Check the value displayed on the intelligent tester when the ignition switch is turned to ON and when the engine is started.


OK:

Condition
Starter Signal
Ignition switch turned to ON
Close
Engine started
Open


Result:

Result
Proceed to
OK
A
NG (for Automatic Transaxle)
B
NG (for Manual Transaxle)
C



B
Go to step 2

C
Go to step 5
A

CHECK FOR INTERMITTENT PROBLEMS 

2.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Inspect the park/neutral position switch assembly (Click here).



NG
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
OK


3.REPAIR OR REPLACE HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - ECM)

NEXT


4.CHECK WHETHER DTC OUTPUT RECURS
  1. Clear the DTCs.

  1. Drive the vehicle at more than 24 km/h (15 mph) for 20 seconds or more.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the intelligent tester ON.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read DTC.

    Result:

    Display (DTC Output)
    Proceed to
    P0617 is output again
    A
    No DTC is output
    B



B
END
A

REPLACE ECM 

5.REPAIR OR REPLACE HARNESS AND CONNECTOR (IGNITION SWITCH - ECM)

NEXT


6.CHECK WHETHER DTC OUTPUT RECURS
  1. Clear the DTCs.

  1. Drive the vehicle at more than 24 km/h (15 mph) for 20 seconds or more.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the intelligent tester ON.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read DTC.

    Result:

    Display (DTC Output)
    Proceed to
    P0617 is output again
    A
    No DTC is output
    B



B
END
A

REPLACE ECM