Home › ENGINE ยท 2TR-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here


CAUTION:
  1. Wear protective gloves when removing the exhaust pipe assembly.
  2. The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
  3. Confirm that the exhaust pipe assembly has cooled down before removing it.



1. REMOVE TAILPIPE ASSEMBLY
  1. Remove the 2 bolts and 2 nuts.

  1. Disconnect the tailpipe from the center pipe and remove the gasket.

  1. Remove the tailpipe from the pipe support.



2. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 nuts.

  1. Disconnect the center pipe from the front pipe and remove the gasket.

  1. Remove the center pipe from the 3 pipe supports.



3. REMOVE AIR FUEL RATIO SENSOR (w/ Secondary Air Injection System)


    G039109E02
  1. Disconnect the sensor connector.

  1. Detach the 3 wire clamps.



    A112981E01
  1. Using SST, remove the sensor.

    SST
    09224-00010  



4. REMOVE HEATED OXYGEN SENSOR (w/o Secondary Air Injection System)


    G039109E02
  1. Disconnect the sensor connector.

  1. Detach the 3 wire clamps.



    A112981E01
  1. Using SST, remove the sensor.

    SST
    09224-00010  



5. REMOVE HEATED OXYGEN SENSOR (w/ Secondary Air Injection System)


    A112117E01
  1. Disconnect the sensor connector.



    A112118E02
  1. Using SST, remove the sensor.

    SST
    09224-00010  



6. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the front pipe from the outlet pipe and remove the gasket.

  1. Remove the front pipe from the pipe support.