Home › ENGINE ยท 2TR-FBE › STARTING › IGNITION SWITCH

IGNITION SWITCH > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE STEERING COLUMN COVER LOWER


    G036625E01
  1. Remove the 3 screws and steering column cover lower.

    HINT:
    Turn the steering wheel to the right and left as necessary to remove the 3 screws and steering column cover lower.



4. DISCONNECT CONNECTOR


    G039728E01
  1. Disconnect the 9 connectors and detach the wire harness clamps from the steering column.



5. REMOVE IGNITION SWITCH ASSEMBLY


    A099992E04
  1. Detach the 2 claws and remove the switch from the steering column bracket upper.