Home › TRANSMISSION ยท CLUTCH › CLUTCH ACCUMULATOR (for 1GR-FE)

CLUTCH ACCUMULATOR (for 1GR-FE) > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH ACCUMULATOR ASSEMBLY


    D100424
  1. Install the clutch accumulator with the 3 bolts.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }



    D100423
  1. Using a union nut wrench, connect the 2 flexible tubes.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque value for situations where a union nut wrench is combined with a torque wrench (Click here).



2. BLEED AIR FROM CLUTCH PIPE LINE
(Click here)


3. CHECK FLUID LEVEL IN RESERVOIR
w/ VSC:
w/o VSC:


4. CHECK FOR CLUTCH FLUID LEAKAGE