CLUTCH UNIT > INSTALLATION |
| 1. INSTALL INPUT SHAFT FRONT BEARING (for 1KD-FTV, 1GR-FE) |
![]() |
Using SST and a hammer, tap in a new bearing.
Install 2 bolts.
for 1GR-FE:
for 1KD-FTV:
| 2. INSTALL INPUT SHAFT FRONT BEARING (for 2TR-FE) |
![]() |
Using SST and a hammer, tap in a new bearing.
Install 2 bolts.
for 2TR-FE:
for 2TR-FBE:
| 3. INSTALL CLUTCH DISC ASSEMBLY |
![]() |
Insert SST into the clutch disc. Then insert SST (together with the clutch disc) into the flywheel.
| 4. INSTALL CLUTCH COVER ASSEMBLY |
![]() |
Align the matchmarks on the clutch cover and flywheel.
Tighten the 6 bolts as described below.
Determine the first bolt to be tightened by choosing the bolt closest to the knock pin.
Uniformly tighten the 6 bolts in diametrically opposite pairs relative to the position of the first bolt. Use the illustration as a reference.
Lightly move SST up and down, and right and left.
Check that the disc is in the center, and then tighten the bolts.
| 5. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY |
![]() |
Using a dial indicator with roller instrument, measure the diaphragm spring tip alignment.
![]() |
| 6. INSTALL RELEASE FORK SUPPORT |
Install the release fork support to the manual transmission unit.
| 7. INSTALL RELEASE BEARING HUB CLIP |
Install the release bearing hub clip to the release bearing.
| 8. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY |
![]() |
Apply Multemp 8158 grease or equivalent to the following areas:
Install the release fork to the release bearing.
| 9. INSTALL CLUTCH RELEASE BEARING ASSEMBLY |
![]() |
Apply clutch spline grease to the input shaft spline.
Install the release fork (with release bearing) to the manual transmission.
| 10. INSTALL CLUTCH RELEASE FORK BOOT |
| 11. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY |
Install the manual transmission unit.
R150/R151 manual transmission: (Click here).
R150F/R151F manual transmission: (Click here).