OIL PUMP > DISASSEMBLY |
| 1. REMOVE FRONT OIL PUMP BODY O-RING |
![]() |
| 2. FIX OIL PUMP ASSEMBLY |
![]() |
Place the oil pump body on the torque converter assembly.
| *1 | Torque Converter Assembly |
| 3. REMOVE CLUTCH DRUM OIL SEAL RING |
![]() |
Remove the 2 oil seal rings.
| 4. REMOVE STATOR SHAFT ASSEMBLY |
![]() |
Remove the 13 bolts, and then remove the stator shaft from the oil pump body.
Remove the oil pump body from the torque converter assembly.
| 5. INSPECT FRONT OIL PUMP BODY |
![]() |
Using a dial indicator, measure the inside diameter of the oil pump body bush.
| 6. INSPECT STATOR SHAFT ASSEMBLY |
![]() |
Using a dial indicator, measure the inside diameter of the stator shaft bush.
| Front Side | Rear Side |
| 21.527 mm (0.847 in.) | 27.026 mm (1.06in.) |
| 7. INSPECT CLEARANCE OF FRONT OIL PUMP BODY |
![]() |
Push the driven gear to one side of the body.
Using a feeler gauge, measure the clearance.
![]() |
Using a feeler gauge, measure the tip clearance between the driven gear teeth and drive gear teeth.
![]() |
Using a steel straightedge and feeler gauge, measure the side clearance of both gears.
| Mark | Specified Condition |
| M | 11.690 to 11.699 mm (0.4603 to 0.4605 in.) |
| N | 11.700 to 11.709 mm (0.4606 to 0.4609 in.) |
| P | 11.710 to 11.720 mm (0.4610 to 0.4614 in.) |
| R | 11.721 to 11.730 mm (0.4615 to 0.4618 in.) |
| S | 11.731 to 11.740 mm (0.4619 to 0.4622 in.) |
| 8. REMOVE FRONT OIL PUMP DRIVE GEAR |
![]() |
| 9. REMOVE FRONT OIL PUMP DRIVEN GEAR |
![]() |
| 10. REMOVE FRONT OIL PUMP OIL SEAL |
![]() |
Using a screwdriver, pry out the oil seal.