Home › TRANSMISSION · A750F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV without i-ART)

DTC    P0500    Vehicle Speed Sensor Malfunction

for Preparation Click here


DESCRIPTION

The speed sensor detects the wheel speed and sends the appropriate signals to the skid control ECU. The skid control ECU converts these wheel speed signals into a pulse signal and outputs it to the TCM via the combination meter. The TCM determines the vehicle speed based on the frequency of this pulse signal.

DTC Code
DTC Detection Condition
Trouble Area
P0500
While the vehicle is being driven, no vehicle speed sensor signal is transmitted to the TCM (2-trip detection logic).
  1. Open or short in speed signal SPD1 circuit
  2. Combination meter system
  3. TCM

MONITOR DESCRIPTION

The TCM assumes that the vehicle is being driven when the indicated vehicle speed is more than 9 km/h (5.6 mph). If there is no speed signal from the combination meter despite this condition being met, the TCM interprets this as a malfunction in the speed signal circuit. The TCM then illuminates the MIL and stores the DTC.

WIRING DIAGRAM


C122128E19


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED)
  1. Drive the vehicle and check whether the operation of the speedometer in the combination meter assembly is normal.

    HINT:
    1. The vehicle speed sensor is operating normally if the speedometer reading is normal.
    2. If the speedometer does not operate, check it by following the procedure described for a speedometer malfunction.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Powertrain / ECT / Data List.

  1. Drive the vehicle.

  1. Read the value displayed on the tester.

    ECT 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Speed
    Vehicle speed/
    Min.: 0 km/h (0 mph)
    Max.: 255 km/h (158 mph)
    Actual vehicle speed
    -

    OK:
    Vehicle speed displayed on the intelligent tester and speedometer display are equal.



NG
Go to step 2
OK

CHECK FOR INTERMITTENT PROBLEMS 

2.CHECK COMBINATION METER SYSTEM


    C217466E08
  1. Remove the combination meter assembly with the connector(s) still connected.

  1. Move the shift lever to N.

  1. Jack up the vehicle.

  1. Turn the ignition switch to ON.

  1. Check the signal waveform according to the condition(s) in the table below.
    Measurement Condition 
    Tester Connection
    Tool Setting
    Condition
    C26-6 - Body ground
    5 V/DIV., 20 msec./DIV.
    Vehicle speed 20 km/h (12 mph)

    OK:
    The waveform is displayed as shown in the illustration.

    Text in Illustration 
    *a
    Component with harness connected
    (Combination Meter Assembly)



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - TCM)
  1. Disconnect the C26 combination meter assembly connector.

  1. Disconnect the T35 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C26-6 - T35-25 (SPD1)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TCM