DTC P0500 Vehicle Speed Sensor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0500 | While the vehicle is being driven, no vehicle speed sensor signal is transmitted to the TCM (2-trip detection logic). |
|

| 1.READ VALUE USING GTS (VEHICLE SPEED) |
Drive the vehicle and check whether the operation of the speedometer in the combination meter assembly is normal.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / ECT / Data List.
Drive the vehicle.
Read the value displayed on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed | Vehicle speed/ Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph) | Actual vehicle speed | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK COMBINATION METER SYSTEM |
Inspect the circuits that send vehicle speed signals to this system in the meter system (Click here).
During inspection for the meter section, if there is an instruction that indicates to go back to inspections for each system, proceed to the next step.
| NEXT | |
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - TCM) |
Disconnect the combination meter assembly connector.
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C26-6 - T35-25 (SPD1) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (JUNCTION CONNECTOR - TCM) |
Disconnect the junction connector.
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2Q-10 - T35-25 (SPD1) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||