DTC P2716/77 Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT) |

![]() |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2716/77 | TCM detects shift solenoid valve SLT circuit malfunction for 1 sec. or more (1 trip detection logic) |
|

| 1.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SLT) |
![]() |
Disconnect the E1 wire connector.
Measure the resistance of the transmission wire.
| Tester Connection | Condition | Specified Condition |
| 2 (SLT+) - 6 (SLT-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| 2 (SLT+) - Body ground | 20°C (68°F) | 10 kΩ or higher |
| 6 (SLT-) - Body ground | 20°C (68°F) | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (TRANSMISSION WIRE - TCM) |
![]() |
Disconnect the T19 TCM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| T19-20 (SLT+) - T19-19 (SLT-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| T19-20 (SLT+) - Body ground | 20°C (68°F) | 10 kΩ or higher |
| T19-19 (SLT-) - Body ground | 20°C (68°F) | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 3.INSPECT SHIFT SOLENOID VALVE SLT |
![]() |
Remove the shift solenoid valve SLT.
Measure the resistance between the solenoid valve terminal and solenoid valve body.
Connect the positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.
Check the operating noise of terminal 1 of the solenoid valve.
![]() |
| Item | Content |
| Tester Connection | T19-20 (SLT+) - T19-19 (SLT-) |
| Tool Setting | 5 V/DIV., 1 msec./DIV. |
| Condition | Engine idle speed |
|
| ||||
| OK | ||
| ||