DTC P0722 Output Speed Sensor Circuit No Signal |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0722 |
|
|

| 1.CHECK SPEED SENSOR (SP2) (INSTALLATION) |
![]() |
Check the speed sensor installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR (SP2) |
![]() |
Disconnect the T8 speed sensor connector from the transmission.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
![]() |
| Item | Content |
| Tester Connection | E10-35 (SP2+) - E10-27 (SP2-) |
| Tool Setting | 2 V/DIV., 2 msec./DIV. |
| Condition | Vehicle speed 20 km/h (12 mph) |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (SPEED SENSOR (SP2) - ECM) |
![]() |
Disconnect the E10 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E10-35 (SP2+) - E10-27 (SP2-) | 20°C (68°F) | 560 to 680 Ω |
| E10-35 (SP2+) - Body ground | 20°C (68°F) | 10 kΩ or higher |
| E10-27 (SP2-) - Body ground | 20°C (68°F) | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||