Home › ENGINE ยท 1KD-FTV › STARTING › IGNITION SWITCH

IGNITION SWITCH > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE STEERING COLUMN COVER LOWER


A111804
  1. Remove the 3 screws and cover lower.

    HINT:
    Turn the steering wheel to the right and left as necessary to remove the 3 screws and cover lower.



4. DISCONNECT CONNECTOR


A111805
  1. Disconnect the 9 connectors and wire harness clamps from the steering column.



5. REMOVE IGNITION SWITCH ASSEMBLY


A111806
  1. Detach the 2 claws and remove the switch from the steering column bracket upper.