Home › ENGINE ยท 1KD-FTV › STARTING › STARTER (for 2.2 kW Type Denso Made)

STARTER (for 2.2 kW Type Denso Made) > INSTALLATION

for Preparation Click here



1. INSTALL STARTER ASSEMBLY


    A122908
  1. A/T:
    Install the starter and ground cable with the 2 nuts and bolt.



    A122907
  1. M/T:
    Install the starter and ground cable with the nut and bolt.

    Torque:
    68 N*m{ 693 kgf*cm , 50 ft.*lbf }

  1. Install the starter wire to terminal 30 with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Attach the terminal cap.

  1. Connect the starter connector.



2. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


G039346E01
  1. Coat a new O-ring with ATF, and install it to the oil filler tube.

  1. Install the oil filler tube with the 2 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

  1. Install the oil dipstick.



3. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY


G034223E01
  1. Install the release cylinder with the 2 bolts.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }



4. INSTALL FRONT FENDER SEAL
  1. Install the seal with the 5 clips.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).