Home › ENGINE ยท 1KD-FTV › STARTING › STARTER (for 2.2 kW Type Denso Made)

STARTER (for 2.2 kW Type Denso Made) > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and seal.



4. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY


G034223E01
  1. Remove the 2 bolts and disconnect the release cylinder.



5. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


G039346E01
  1. Remove the oil dipstick.

  1. Remove the 2 bolts and oil filler tube.

  1. Remove the O-ring from the oil filler tube.



6. REMOVE STARTER ASSEMBLY


A111843
  1. Disconnect the starter connector.

  1. Open the terminal cap.

  1. Remove the nut and disconnect the starter wire.



    A122908
  1. A/T:
    Remove the 2 nuts, bolt, ground cable and starter.



    A122907
  1. M/T:
    Remove the nut, bolt, ground cable and starter.