STARTER (for 2.2 kW Type Denso Made) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT FENDER SEAL |
Remove the 5 clips and seal.
| 4. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY |
![]() |
Remove the 2 bolts and disconnect the release cylinder.
| 5. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY |
![]() |
Remove the oil dipstick.
Remove the 2 bolts and oil filler tube.
Remove the O-ring from the oil filler tube.
| 6. REMOVE STARTER ASSEMBLY |
![]() |
Disconnect the starter connector.
Open the terminal cap.
Remove the nut and disconnect the starter wire.
![]() |
A/T:
Remove the 2 nuts, bolt, ground cable and starter.
![]() |
M/T:
Remove the nut, bolt, ground cable and starter.