Home › ENGINE ยท 2KD-FTV › STARTING › STARTER (for 2.0 kW Type)

STARTER (for 2.0 kW Type) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and front fender seal.



4. REMOVE CLUTCH RELEASE CYLINDER ASSEMBLY


C113783
  1. Remove the 2 bolts and clutch release cylinder.



5. REMOVE STARTER ASSEMBLY


    A195903
  1. Disconnect the starter connector.

  1. Remove the nut and disconnect the starter wire.



    A195904
  1. Remove the nut and bolt, and disconnect the ground cable.

  1. Remove the starter.