Home › ENGINE · 2KD-FTV › STARTING › GLOW PLUG

GLOW PLUG > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK GLOW PLUG


A111828E07
  1. Remove the screw grommet.
    Text in Illustration 
    *1
    Screw Grommet

  1. Measure the resistance of according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Glow plug terminal - Body ground
    20°C (68°F)
    Approx. 0.95 Ω

    1. If the result is not as specified, replace the glow plug.

    NOTICE:
    1. Be careful not to damage the glow plug pipes, as this may cause an open circuit or shorten the life of the glow plugs.
    2. Do not allow oil or gasoline to contact the glow plug when cleaning it.
    3. Clean any oil on the terminal and bakelite washer with a dry cloth.
    4. Do not apply more than 11 V to the glow plug, as this may cause an open circuit.