Home › ENGINE ยท 1KD-FTV › STARTING › PRE-HEATING SYSTEM (w/o Glow Plug Controller)

PRE-HEATING SYSTEM (w/o Glow Plug Controller) > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ILLUMINATION DURATION OF GLOW INDICATOR LIGHT


  1. Check the light illumination duration.


    A113412E01


    1. Turn the ignition switch ON, and then measure the light illumination duration.

      Light illumination duration:
      See graph.

      1. If the result is not as specified, inspect the ECM, ECT sensor, glow plug and GLOW relay.

      HINT:
      Actual light illumination duration may vary slightly from the graph.

    2. Turn the ignition switch OFF.



2. CHECK PRE-HEATING


  1. Inspect the pre-heating time.


    A111826E02


    1. Turn the ignition switch ON. Measure how long it takes for battery voltage to be applied to the glow plugs.

      Standard pre-heating time:
      Engine Coolant Temperature
      Specified Condition
      40°C (104°F) or higher
      1 second
      Below 40°C (104°F)
      See graph
      (maximum: 15 seconds)

      1. If the result is not as specified, inspect the ECM, ECT sensor, glow plug and GLOW relay.

    2. Turn the ignition switch OFF.

  1. Turn the ignition switch to START. Check that battery voltage is applied to the glow plugs.

  1. While cranking the engine, measure how long it takes for battery voltage to be applied to the glow plugs.

    Standard pre-heating time:
    Engine Coolant Temperature
    Specified Condition
    40°C (104°F) or higher
    1 second
    Below 40°C (104°F)
    See graph
    (maximum: 15 seconds)

    1. If the result is not as specified, inspect the ECM, ECT sensor, glow plug and GLOW relay.



3. CHECK AFTERGLOW TIME


  1. Check the afterglow time.



    1. After the engine starts, measure how long it takes for battery voltage to be applied to terminals E4-15 (GREL) and E6-7 (E1) of the ECM.

      Standard afterglow time:
      Tester Connection
      Specified Condition
      E4-15 (GREL) - E6-7 (E1)
      See graph



      A113414E03

      1. If the result is not as specified, inspect the ECM, ECT sensor, glow plug and GLOW relay.