Home › ENGINE ยท 2KD-FTV › CHARGING › GENERATOR

GENERATOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE AIR CLEANER ASSEMBLY
  1. Disconnect the mass air flow meter connector.

  1. Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner.



4. REMOVE FAN AND GENERATOR V BELT


    A272228E01
  1. Rotate the tensioner pulley clockwise to loosen the belt and reduce the tension. Then remove the V belt.
    Text in Illustration 
    *1
    Cooler Compressor
    *2
    Fan Pulley
    *3
    Generator
    *4
    Tensioner
    *5
    Crankshaft Pulley



5. REMOVE NO. 2 IDLER PULLEY ASSEMBLY


A233180
  1. Remove the bolt, pulley plate, No. 2 idle pulley and spacer.



6. REMOVE GENERATOR ASSEMBLY


A195391
  1. Remove the nut and generator wire.

  1. Disconnect the generator connector.

  1. Remove the 2 bolts and generator.