Home › ENGINE ยท 1KD-FTV › ENGINE CONTROL SYSTEM › ECM (w/o Glow Plug Controller)

ECM (w/o Glow Plug Controller) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 ECM BRACKET
  1. Install the bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



2. INSTALL NO. 1 ECM BRACKET
  1. Install the bracket with the 3 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



3. INSTALL ECM


    A111798
  1. Install the ECM with the bolt and 2 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the 4 connectors.



4. INSTALL TRANSMISSION CONTROL ECU ASSEMBLY (for Automatic Transmission)


    A111797
  1. Install the TCM with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the 3 connectors.



5. INSTALL TURBO MOTOR DRIVER


    A111796
  1. Install the turbo motor driver with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.



6. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


B278068E01
  1. Attach the 2 hinges to install the glove compartment door.
    Text in Illustration 
    *1
    Hinge



    B278069E01
  1. While pushing in the sides of the glove compartment door as indicated by the arrows in the illustration, close the door to engage it to the 2 stoppers.
    Text in Illustration 
    *1
    Stopper



7. PERFORM REGISTRATION
  1. Perform registration (w/ EGR Cooler: Click here, w/o EGR Cooler : Click here).

    HINT:
    Only perform registration when the ECM is replaced, either by itself or in any of the following combinations.
    1. ECM and Fuel Supply Pump
    2. ECM and Diesel Throttle Body Assembly
    3. ECM and Injector Assembly
    4. ECM and Engine Assembly



8. START ENGINE
  1. When replacing the ECM, start the engine to initialize the new ECM (w/ EGR Cooler: Click here, w/o EGR Cooler: Click here).