Home › ENGINE ยท 1KD-FTV › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > INSTALLATION

for Preparation Click here



1. INSTALL ACCELERATOR PEDAL ROD ASSEMBLY

NOTICE:
  1. Avoid excessive force to the accelerator pedal sensor.
  2. Do not disassemble the accelerator pedal sensor assembly.
  3. This accelerator pedal does not require lubrication.
    Do not apply oil or lubricant to the accelerator pedal sensor assembly.
    If applied, the accelerator pedal sensor assembly must be replaced.

  1. Install the pedal rod with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the accelerator pedal position sensor connector.