EMISSION CONTROL SYSTEM (w/ Glow Plug Controller) > ON-VEHICLE INSPECTION |
| 1. CHECK SEATING OF EGR VALVE |
Check that the engine starts and idles.
Stop the engine.
| 2. CHECK EGR VALVE OPERATION |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Active Test / Control the EGR Step Position.
Check the values of Target EGR Position and Actual EGR valve pos in the Data List.
| Control Range Condition | Specified Condition |
| Active Test performed (Set EGR position to 0% → 30% → 60% → 90% → 60% → 30% → 0%) | Actual EGR valve opening percentage changes according to Active Test operation |
| 3. VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS |
Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.
| 4. CHECK VACUUM PUMP ASSEMBLY |
![]() |
Disconnect the vacuum hose from the vacuum pump.
Connect the hose of a vacuum gauge to the pump.
Insert a plug into the other hose of the gauge.
Start the engine and warm it up for more than 2 minutes.
With the engine idling, check the negative pressure of the pump.
Remove the gauge from the pump.
Connect the hose to the pump with the clip.