EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION |
| 1. VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS |
Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.
| 2. CHECK VACUUM PUMP ASSEMBLY |
![]() |
Disconnect the vacuum hose from the vacuum pump.
Connect the hose of a vacuum gauge to the pump.
Insert a plug into the other hose of the gauge.
Start the engine and warm it up for more than 2 minutes.
With the engine idling, check the negative pressure of the pump.
Remove the gauge from the pump.
Connect the hose to the pump with the clip.