Home › ENGINE ยท 1KD-FTV › EMISSION CONTROL › VACUUM SWITCHING VALVE (w/o Glow Plug Controller)

VACUUM SWITCHING VALVE (w/o Glow Plug Controller) > INSTALLATION

for Preparation Click here



1. INSTALL VACUUM SWITCHING VALVE (for EGR Bypass Valve)
  1. w/ EGR Cooler:

    1. Install the vacuum switching valve to the manifold stay with the screw.

      Torque:
      3.5 N*m{ 36 kgf*cm , 31 in.*lbf }



2. INSTALL VACUUM SWITCHING VALVE (for EGR Cut)
  1. Install the vacuum switching valve with the screw.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }



3. CONNECT NO. 3 VACUUM TRANSMITTING HOSE (w/ EGR Cooler)
  1. Connect the vacuum hose to the VSV (for No. 2 EGR valve) shown in the illustration below.



4. CONNECT NO. 1 VACUUM TRANSMITTING HOSE (w/ EGR Cooler)
  1. Connect the vacuum hose to the VSV (for E-VRV) shown in the illustration below.



5. CONNECT NO. 2 VACUUM TRANSMITTING HOSE (w/ EGR Cooler)


  1. Connect the vacuum hose to the VSV (for electric EGR control valve) shown in the illustration below.


    A148630E01



6. INSTALL MANIFOLD STAY WITH VACUUM SWITCHING VALVE (w/ EGR Cooler)


    A148631E01
  1. Install the manifold stay with VSV with the 2 bolts, and connect the No. 1 vacuum transmitting hose (color is "Blue") to the No. 2 vacuum transmitting pipe.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

    NOTICE:
    Install the vacuum hoses so that they completely cover the pipes.



    A148632E01
  1. Connect the 3 vacuum hoses.

    NOTICE:
    1. Install the vacuum hoses so that they completely cover the pipes.
    2. Make sure the vacuum hoses' color matches the connection areas' color.

  1. Connect the 2 connectors.



7. INSTALL ELECTRIC VACUUM REGULATING VALVE ASSEMBLY (w/o EGR Cooler)
  1. w/ EGR Cooler:

    1. Install the electric vacuum regulating valve together with the bracket with the 2 bolts.

      Torque:
      20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    2. Connect the 4 vacuum hoses.

      NOTICE:
      Install the vacuum hoses so that they completely cover the pipes.

    3. Connect the connector.

  1. w/o EGR Cooler:

    1. Install the vacuum switching valve with the screw.

      Torque:
      3.5 N*m{ 36 kgf*cm , 31 in.*lbf }

    2. Install the electric vacuum regulating valve together with the bracket with the 2 bolts.

      Torque:
      20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    3. Connect the 3 vacuum hoses.

    4. Connect the 2 connectors.



8. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
  1. Install the engine cover with the 3 bolts and 2 cap nuts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }