Home › ENGINE ยท 2TR-FBE › EMISSION CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)


    G039121E01
  1. Using SST, install the air fuel ratio sensor.

    SST
    09224-00010  

    Torque:
    for use without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    for use with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    1. Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
    2. Make sure SST and the wrench are connected in a straight line.

  1. Attach the 3 wire harness clamps to the vehicle body.

  1. Connect the air fuel ratio sensor connector.