Home › ENGINE ยท 2KD-FTV › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A099591
  1. Drain the coolant by removing the radiator reservoir cap and, using a wrench, remove the vent plug.



  1. Loosen the cylinder block drain cock plug.


    A112147E03


    Text in Illustration 
    *1
    Radiator Reservoir
    *2
    Radiator Reservoir Cap
    *3
    Vent Plug
    *4
    Cylinder Block Drain Cock Plug
    *5
    Radiator Drain Cock Plug
    -
    -



3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A099256E03
  1. Detach the 4 claws from the pins of the engine cover bracket and remove the No. 1 engine cover sub-assembly.
    Text in Illustration 
    *1
    No. 1 Engine Cover Sub-assembly
    *2
    Claw
    *3
    Pin

  1. Remove the 2 bolts and engine cover bracket.



    A111789
  1. Disconnect the manifold absolute pressure sensor connector.

  1. Disconnect the vacuum hose from the gas filter.

  1. Loosen the 2 clamps.

  1. Remove the bolt and disconnect the No. 2 air cleaner pipe sub-assembly together with the 2 air hoses.



4. REMOVE VENTILATION HOSE HEAT INSULATOR
  1. Remove the 2 bolts and ventilation hose heat insulator.



5. REMOVE AIR CLEANER ASSEMBLY
  1. Disconnect the mass air flow meter connector.

  1. Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner.



6. DISCONNECT NO. 1 AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP (for Automatic Transmission)


    A097634E01
  1. Remove the bolt and disconnect the No. 1 automatic transmission oil cooler tube clamp.



7. DISCONNECT RADIATOR HOSE OUTLET
  1. Disconnect the radiator hose outlet from the water inlet.



8. REMOVE WATER INLET


A250419
  1. Disconnect the wire harness clamp.

  1. Remove the 3 bolts and water inlet.

  1. Remove the bolt and wire harness clamp bracket from the water inlet.



9. REMOVE THERMOSTAT
  1. Remove the thermostat from the cylinder block.

  1. Remove the gasket from the thermostat.