THERMOSTAT > INSTALLATION |
| 1. INSTALL THERMOSTAT |
![]() |
Install a new gasket to the thermostat.
Insert the thermostat into the cylinder block with the jiggle valve facing straight upward.
| 2. INSTALL WATER INLET |
Install the inlet with the 2 nuts and bolt.
Connect the connector.
| 3. CONNECT RADIATOR HOSE OUTLET |
Connect the hose to the water inlet.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. ADD ENGINE COOLANT |
Tighten all the plugs and fill the radiator with TOYOTA Super Long Life Coolant (SLLC).
| Item | Specified Condition |
| A/T | 8.1 liters (8.6 US qts, 7.1 Imp. qts) |
| M/T | 7.8 liters (8.2 US qts, 6.9 Imp. qts) |
Fill the radiator with TOYOTA SLLC to the MAX line.
Press the inlet and outlet radiator hoses several times by hand, and then check the level of the coolant.
If the coolant level drops below the MAX line, add TOYOTA SLLC to the MAX line.
Install the radiator cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens. While the thermostat is open, circulate the coolant for several minutes.
Maintain the engine speed at 2,000 to 2,500 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine and wait until the coolant cools down to ambient temperature.
![]() |
Check the coolant level in the radiator reservoir.
If the coolant level is below the MIN line, add SLLC to the reservoir MAX line.
| 6. CHECK FOR ENGINE COOLANT LEAKS |
Check for engine coolant leaks .
| 7. INSTALL NO. 1 ENGINE UNDER COVER |
Install the cover with the 4 bolts.
| 8. PERFORM INITIALIZATION |
Perform initialization (Click here).