Home › ENGINE ยท 1GR-FE › COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and under cover.



4. DRAIN ENGINE COOLANT
  1. Remove the radiator cap.



  1. Loosen the 2 cylinder block drain cock plugs and radiator drain cock plug, and then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A110401E01



5. REMOVE V-BANK COVER
  1. Remove the 2 nuts and cover.



6. DISCONNECT RADIATOR HOSE INLET
  1. Disconnect the hose inlet from the radiator tank upper.



7. DISCONNECT RADIATOR HOSE OUTLET
  1. Disconnect the hose outlet from the radiator tank lower.



8. REMOVE FAN SHROUD


A112136
  1. Disconnect the radiator reservoir hose from the radiator tank upper.

  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the drive belt .

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.



9. DISCONNECT NO. 2 VENTILATION HOSE


A075594E01


10. REMOVE AIR CLEANER ASSEMBLY


    A075595
  1. Disconnect the vacuum hose.

  1. Disconnect the MAF meter connector.

  1. Remove the 2 wire harness clamps.



    A075596
  1. Loosen the 2 hose clamps.

  1. Remove the 2 bolts and air cleaner.



11. REMOVE WATER INLET HOUSING


A076335E01
  1. Disconnect the 2 radiator hoses from the housing.



    A076336E01
  1. Disconnect the 3 water by-pass hoses.



    A076337E01
  1. Remove the 5 bolts and water inlet.

  1. Remove the O-ring from the water outlet pipe.

  1. Remove the O-ring from the water pump.



12. REMOVE NO. 2 IDLER PULLEY

NOTICE:
Use the same procedure for both No. 2 idler pulleys.



  1. w/ Idler Pulley Cover Plate:



      A191314E01
    1. Remove the bolt, No. 2 idler pulley cover plate, idler pulley and idler pulley cover plate.



  1. w/o Idler Pulley Cover Plate:



      A191315E01
    1. Remove the bolt, No. 2 idler pulley cover plate and idler pulley.



    A076338E01
  1. for Integrated Type:
    Remove the 2 bolts and 2 No. 2 idler pulleys.



13. REMOVE GENERATOR ASSEMBLY


A112761
  1. Disconnect the terminal cap.

  1. Remove the 2 bolts, nut and generator wire.

  1. Disconnect the generator connector.

  1. Remove the 2 bolts and generator.



14. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY


    G035081E01
  1. Remove the 3 bolts and belt tensioner.



15. REMOVE WATER PUMP ASSEMBLY


A072954E01
  1. Remove the 17 bolts, water pump and gasket.