Home › ENGINE ยท 1GR-FE › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here


HINT:
If the thermostat was not installed, cooling efficiency would be harmed. Even if the engine tends to overheat, do not remove the thermostat.



1. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and under cover.



2. DRAIN ENGINE COOLANT
  1. Remove the radiator cap.



  1. Loosen the cylinder block drain cock plug and radiator drain cock plug, and then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A270641E01



3. REMOVE V-BANK COVER


    A112983
  1. Remove the 2 nuts and V-bank cover.



4. DISCONNECT RADIATOR HOSE OUTLET


5. REMOVE WATER INLET HOUSING WITH THERMOSTAT


    A112082
  1. Remove the 3 nuts, water inlet housing with thermostat and gasket.