Home › ENGINE ยท 1GR-FE › COOLING › RADIATOR

RADIATOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and cover.



4. REMOVE RADIATOR GRILLE


    B277882
  1. Remove the 2 clips and 2 screws.



    B277883E01
  1. Put protective tape around the radiator grille.
    Text in Illustration 
    *1
    Protective Tape

  1. Detach the 6 claws and remove the radiator grille.



5. REMOVE RADIATOR SIDE DEFLECTOR LH


    A120283
  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.



6. REMOVE RADIATOR SIDE DEFLECTOR RH
  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.



7. DRAIN ENGINE COOLANT
  1. Remove the radiator cap.



  1. Loosen the 2 cylinder block drain cock plugs and radiator drain cock plug, and then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A110401E01



8. DISCONNECT RADIATOR HOSE INLET


9. DISCONNECT RADIATOR HOSE OUTLET


10. DISCONNECT NO. 1 OIL COOLER INLET TUBE (for Automatic Transmission)
  1. Disconnect the inlet tube from radiator tank lower.



11. DISCONNECT NO. 1 OIL COOLER OUTLET TUBE (for Automatic Transmission)
  1. Disconnect the outlet tube from radiator tank lower.



12. REMOVE FAN SHROUD


    A110406
  1. Remove the 3 bolts and oil reservoir.

  1. Disconnect the reservoir hose from the radiator tank upper.

  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the drive belt .

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts holding the fluid coupling fan, and then remove the shroud together with the fluid coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.



13. REMOVE RADIATOR ASSEMBLY


    A112139
  1. Disconnect the 2 front airbag sensor connectors.

  1. Using a clip remover, detach the 4 clamps shown in the illustration from the radiator side.

    HINT:
    Tape the clip remover tip before use.



    A112140
  1. Remove the 4 bolts and radiator.