COOLANT > ON-VEHICLE INSPECTION |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 4 bolts and under cover.
| 2. DRAIN ENGINE COOLANT |
Remove the radiator cap.
Loosen the 2 cylinder block drain cock plugs and radiator drain cock plug, and then drain the coolant.

| 3. ADD ENGINE COOLANT |
Tighten all the plugs and fill the radiator with TOYOTA Super Long Life Coolant (SLLC).
| Item | Specified Condition |
| A/T | 9.8 liters (10.4 US qts, 8.6 Imp. qts) |
| M/T | 8.5 liters (9.0 US qts, 7.5 Imp. qts) |
Fill the radiator reservoir with TOYOTA Super Long Life Coolant (SLLC) to the F line.
Install the radiator cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens.
While the thermostat is open, circulate the coolant for several minutes.
Maintain the engine speed at 2,500 to 3,000 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine and wait until the coolant cools down to ambient temperature.
![]() |
Check the coolant level in the radiator reservoir.
If the coolant level is below the L line, add SLLC to the reservoir F line.
| 4. CHECK FOR ENGINE COOLANT LEAKS |
Check for engine coolant leaks .
| 5. INSTALL NO. 1 ENGINE UNDER COVER |
Install the under cover with the 4 bolts.