CYLINDER HEAD > REPLACEMENT |
| 1. REPLACE INTAKE VALVE GUIDE BUSH |
Gradually heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
![]() |
Using SST and a hammer, tap out the valve guide bush.
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
Select a new guide bush.
| Item | Specified Condition | |
| Bush bore diameter | 10.985 to 11.006 mm (0.432 to 0.433 in.) | 11.035 to 11.056 mm (0.434 to 0.435 in.) |
| Bush to be used | STD | O/S 0.05 |
Gradually heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
![]() |
Using SST and a hammer, tap in a new guide bush to the specified protrusion height.
![]() |
Using a sharp 6.0 mm reamer, ream the guide bush to obtain the standard clearance between the guide bush and valve stem.
| *1 | Sharp 6.0 mm Reamer |
| 2. REPLACE EXHAUST VALVE GUIDE BUSH |
Gradually heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
![]() |
Using SST and a hammer, tap out the valve guide bush.
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
Select a new guide bush.
| Item | Specified Condition | |
| Bush bore diameter | 10.985 to 11.006 mm (0.432 to 0.433 in.) | 11.035 to 11.056 mm (0.434 to 0.435 in.) |
| Bush to be used | STD | O/S 0.05 |
Gradually heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
![]() |
Using SST and a hammer, tap in a new guide bush to the specified protrusion height.
![]() |
Using a sharp 6.0 mm reamer, ream the guide bush to obtain the standard clearance between the guide bush and valve stem.
| *1 | Sharp 6.0 mm Reamer |
| 3. REPLACE RING PIN |
Remove the ring pin.
Using a plastic-faced hammer, tap in a new ring pin until the pin stops.

| *a | Less than 5 mm (0.197 in.) | - | - |