CYLINDER HEAD > REASSEMBLY |
| 1. INSTALL STUD BOLT |
Install the stud bolts.

| *1 | Stud Bolt A | *2 | Stud Bolt B |
| *3 | Stud Bolt C | *4 | Stud Bolt D |
| *5 | Stud Bolt E | - | - |
| *a | Front Side | *b | Intake Manifold Side |
| *c | Cylinder Head Cover Side | *d | Exhaust Manifold Side |
| 2. INSTALL NO. 1 STRAIGHT SCREW PLUG |
Apply adhesive to the end of each No. 1 straight screw plug.
Using a 6 mm hexagon wrench, install the No. 1 straight screw plugs.

| *1 | Adhesive | - | - |
| 3. INSTALL SEMICIRCULAR PLUG |
Remove any old seal packing (FIPG material).
Apply seal packing to the semicircular plug as shown in the illustration.

| *1 | Seal Packing | - | - |
Install the semicircular plug to the cylinder head.
| 4. INSTALL INTAKE VALVE STEM OIL SEAL |
![]() |
Using SST, push in new oil seals.
| 5. INSTALL EXHAUST VALVE STEM OIL SEAL |
Using SST, push in new oil seals.
| 6. INSTALL INTAKE VALVE |
![]() |
Apply a sufficient coat of engine oil to the tip area of the valve shown in the illustration.
| *a | 30 mm (1.18 in.) or more |
![]() |
Install the valve, spring seat, compression spring and spring retainer.
Using SST, compress the compression spring and install the 2 valve spring retainer locks to the valve stem.
Using a plastic-faced hammer, lightly tap the valve stem tip to assure a proper fit.
| 7. INSTALL EXHAUST VALVE |
![]() |
Apply a sufficient coat of engine oil to the tip area of the valve shown in the illustration.
| *a | 30 mm (1.18 in.) or more |
![]() |
Install the valve, spring seat, compression spring and spring retainer.
Using SST, compress the compression spring and install the 2 valve spring retainer locks to the valve stem.
Using a plastic-faced hammer, lightly tap the valve stem tip to assure a proper fit.