ENGINE UNIT > REPLACEMENT |
| 1. REPLACE TIMING GEAR COVER OIL SEAL |
If the timing gear cover is removed from the cylinder block:
![]() |
Using a screwdriver and hammer, tap out the oil seal.
![]() |
Using SST and a hammer, tap in a new oil seal unit its surface is flush with the timing gear cover edge.
Apply MP grease to the oil seal lip.
If the timing gear cover is installed to the cylinder block:
![]() |
Using a knife, cut through the oil seal lip.
Using a screwdriver, pry out the oil seal.
Apply MP grease to the oil seal lip.
![]() |
Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.
| 2. REPLACE TIMING GEAR COVER OIL SEAL |
If the timing gear cover is removed from the cylinder block.
![]() |
Using a screwdriver and a hammer, tap out the oil seal.
![]() |
Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.
Apply MP grease to a new oil seal lip.
If the timing gear cover is installed to the cylinder block.
![]() |
Using SST, remove the oil seal.
![]() |
Apply MP grease to a new oil seal lip.
Using SST and a hammer, tap in the oil seal until its surface is flush with the timing gear cover edge.
| 3. REPLACE REAR ENGINE OIL SEAL |
![]() |
Using a screwdriver and hammer, tap out the oil seal.
![]() |
Using SST and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal retainer edge.
Apply MP grease to the oil seal lip.