ENGINE UNIT > INSPECTION |
| 1. INSPECT INJECTION GEAR BEARING |
Check that the bearing is not rough or worn.
If necessary, replace the injection gear.
| 2. INSPECT NO. 1 IDLE GEAR OIL CLEARANCE |
![]() |
Using a cylinder gauge, measure the inside diameter of the idle gear.
![]() |
Using a micrometer, measure the diameter of the idle gear shaft.
Subtract the idle gear shaft diameter measurement from the idle gear inside diameter measurement.
| 3. INSPECT INTAKE MANIFOLD |
![]() |
Using a precision straightedge and feeler gauge, measure the warpage of the surface of the intake manifold that contacts the cylinder head.
| 4. INSPECT EXHAUST MANIFOLD |
![]() |
Using a precision straightedge and feeler gauge, measure the warpage of the surface of the exhaust manifold that contacts the cylinder head.
| 5. INSPECT CAMSHAFT |
Inspect the circle runout.
Place the camshaft on V-blocks.
Using a dial indicator, measure the circle runout at the center journal.
Inspect the cam lobe height.
Using a micrometer, measure the cam lobe height.
Inspect the diameter of the camshaft journal.
Using a micrometer, measure the diameter of the camshaft journal for the camshaft bearing.
![]() |
Using a dial indicator, measure the backlash.
Install the 2 camshafts.
Using a dial indicator, measure the backlash.
Remove the 2 camshafts.
| 6. INSPECT NO. 2 CAMSHAFT |
Inspect the circle runout.
Place the camshaft on V-blocks.
Using a dial indicator, measure the circle runout at the center journal.
Inspect the cam lobe height.
Using a micrometer, measure the cam lobe height.
Inspect the diameter of the camshaft journal.
Using a micrometer, measure the diameter of the camshaft journal for the camshaft bearing.
| 7. INSPECT CAMSHAFT OIL CLEARANCE |
Clean the bearing caps and journals.
Check the bearings for flaking and scoring.
If the bearings are damaged, replace the bearing caps and cylinder head as a set.
Place the camshaft on the cylinder head.
![]() |
Lay a strip of Plastigage across each of the journals.
| *A | Intake Side |
| *B | Exhaust Side |
| *1 | Plastigage |
Install the bearing caps.
Remove the bearing caps.
![]() |
Measure the Plastigage at its widest point.
| *A | Intake Side |
| *B | Exhaust Side |
| *1 | Plastigage |
Completely remove the Plastigage.
Remove the camshaft.
| 8. INSPECT CAMSHAFT THRUST CLEARANCE |
Install the camshaft.
![]() |
Using a dial indicator, measure the thrust clearance while moving the camshaft back and forth.
| *A | Intake Side |
| *B | Exhaust Side |
Remove the camshaft.
| 9. INSPECT CYLINDER HEAD SET BOLT |
![]() |
Using a vernier caliper, measure the diameter of the most elongated threads in the measurement area.