Home › ENGINE ยท 2KD-FTV › ENGINE MECHANICAL › CYLINDER BLOCK

CYLINDER BLOCK > REPLACEMENT

for Preparation Click here



1. REPLACE CYLINDER BLOCK TIGHT PLUG

NOTICE:
If coolant leaks from a tight plug or a plug is corroded, replace it.

  1. Remove the tight plugs.

  1. Apply adhesive to new tight plugs.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    NOTICE:
    Do not start the engine for 1 hour after installation.

  1. Position A:
    Using a 14 mm steel bar and hammer, tap in the tight plug as shown in the illustration.



  1. Other positions:
    Using SST and a hammer, tap in the tight plugs as shown in the illustration.
    Position B

    SST
    09950-60010   (09951-00180)
    09950-70010   (09951-07100)
    Position C
    SST
    09950-60010   (09951-00190)
    09950-70010   (09951-07100)
    Position D
    SST
    09950-60010   (09951-00200)
    09950-70010   (09951-07100)
    Position E and H
    SST
    09950-60010   (09951-00350)
    09950-70010   (09951-07100)
    Position F
    SST
    09950-60010   (09951-00400, 09951-00450)
    09950-70010   (09951-07100)
    Position G
    SST
    09950-60010   (09951-00450)
    09950-70010   (09951-07100)


    A152216E05


    Text in Illustration 
    *1
    Stops
    -
    -
    *a
    Right Side
    *b
    Left Side
    *c
    Front Side
    *d
    Rear Side



2. REPLACE STRAIGHT PIN

NOTICE:
It is not necessary to remove a straight pin unless it is being replaced.

  1. Remove the straight pins.



  1. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.

    Standard Protrusion Height:
    Item
    Specified Condition
    Pin A
    7.5 mm (0.295 in.) or less
    Pin B
    6 mm (0.234 in.) or less
    Pin C
    12 mm (0.472 in.) or less



    A256495E01


    Text in Illustration 
    *1
    Pin A
    *2
    Pin B
    *3
    Pin C
    *4
    Protrusion Height
    *a
    Front Side
    *b
    Rear Side



3. REPLACE RING PIN

NOTICE:
It is not necessary to remove a ring pin unless it is being replaced.

  1. Remove the ring pins.



  1. Using a plastic-faced hammer, tap in new ring pins to the cylinder block.

    Standard Protrusion:
    6 mm (0.236 in.) or less



    A256496E01


    Text in Illustration 
    *a
    Cylinder Head Side
    *b
    6 mm (0.236 in.) or less



4. REPLACE CYLINDER BLOCK WATER DRAIN PLUG
  1. Remove the cylinder block water drain plug from the cylinder block.

  1. Clean the cylinder block side hole and new cylinder block water drain plug with non-residue solvent.



    A330617E02
  1. Apply adhesive onto the shaded area of a cylinder block water drain plug as shown in the illustration.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    NOTICE:
    Install the cylinder block water drain plug within 3 minutes after applying adhesive.

  1. Set the cylinder block water drain plug and tap it until the edge of the cylinder block water drain plug fits against the chamfered part of the cylinder block as shown in the illustration.