Home › BODY ELECTRICAL › LIGHTING › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. INSTALL TRANSPONDER KEY AMPLIFIER


    G034429E01
  1. Align the amplifier with the installation position of the upper bracket.

  1. Push up the amplifier and connect it to the upper bracket.

    NOTICE:
    Do not apply excessive force to the amplifier as it may be damaged.



2. INSTALL STEERING COLUMN COVER UPPER


3. INSTALL STEERING COLUMN COVER LOWER


    C238860
  1. Install the lower cover with the 3 screws.



4. INSTALL STEERING WHEEL ASSEMBLY


    G039075E04
  1. Align the matchmarks on the steering wheel and main shaft.

  1. Install the steering set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



5. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


6. INSPECT STEERING WHEEL CENTER POINT


7. INSTALL STEERING PAD ASSEMBLY


    B278764
  1. Support the steering pad with one hand.

  1. Connect the connector to the steering pad.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Connect the horn connector.

  1. Confirm that the groove along the circumference of the "TORX" screw is attached to the screw case and place the steering pad onto the steering wheel.

  1. Using a T30 "TORX" socket wrench, tighten the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


9. INSPECT STEERING PAD ASSEMBLY
  1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
    Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.

  1. Make sure that the horn sounds.
    If the horn does not sound, inspect the horn system.



10. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



11. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).