PRE-HEATING SYSTEM (w/ Glow Plug Controller) > ON-VEHICLE INSPECTION |
| 1. INSPECT ILLUMINATION DURATION OF GLOW INDICATOR LIGHT |
![]() |
Turn the ignition switch to ON and measure the length of time that the light remains illuminated.
| *a | Glow Indicator Light Illumination Time |
| *b | Engine Coolant Temperature |
| *c | When atmospheric pressure is 100 kPa (1.0 kgf/cm2) |
| 2. INSPECT PRE-HEATING FUNCTION |
Measure the voltage applied to the glow plugs.
Measure the length of time that voltage is applied to the glow plugs while the ignition switch is ON.
| Condition | Pre-heating Time |
| Battery voltage at 14.5 V or higher | 1 second |
| Engine coolant temperature 40°C (104°F) or higher | 1 second |
| Other than above | 15 seconds |
| 3. INSPECT AFTER GLOW |
Measure the voltage applied to the glow plugs after the engine is started.
| Measurement Condition | Specified Condition |
| Engine coolant temperature 20°C (68°F) or less | 11 to 14 V |
| Engine coolant temperature 20°C (68°F) to 41°C (106°F) | 0 to 14 V |
| Engine coolant temperature 41°C (106°F) or higher | 0 V |