FUEL PRESSURE PULSATION DAMPER > INSTALLATION |
| 1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY |
Apply a light coat of spindle oil or gasoline to a new O-ring and install it to the fuel pressure pulsation damper.
Install the fuel pressure pulsation damper to the fuel delivery pipe.
![]() |
Install the clip.
| 2. INSTALL INTAKE AIR SURGE TANK |
![]() |
Install a new gasket to the intake air surge tank.
Using an 8 mm socket hexagon wrench, install the intake air surge tank with the 4 bolts and 2 nuts.
![]() |
Install the 2 surge tank stays with the 4 bolts.
Install the oil baffle plate with the bolt.
![]() |
Install the throttle body bracket with the 2 bolts.
Install the 3 wire harness clamps and hose clamp.
Connect the throttle position sensor and control motor connector.
Connect the 2 VSV connectors.
![]() |
Connect the ventilation hose.
![]() |
Connect the fuel vapor feed hose.
![]() |
Connect the 2 water by-pass hoses.
| 3. INSTALL AIR CLEANER ASSEMBLY |
| 4. CONNECT NO. 2 VENTILATION HOSE |
![]() |
| 5. INSTALL V-BANK COVER |
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. CHECK FOR FUEL LEAKS |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Push the intelligent tester main switch ON.
To perform the Active Test, enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check the fuel pump operation.
Check for pressure in the fuel inlet tube from the fuel line. Check that the sound of fuel flowing in the fuel tank can be heard.
If there is no sound, check the integration relay, fuel pump, ECM and wiring connector.
Check for fuel leaks.
Check that there are no fuel leaks after performing maintenance anywhere on the system.
If there are fuel leaks, repair or replace the leaking parts.