Home › ENGINE · 1KD-FTV › FUEL › FUEL SUPPLY PUMP (w/ Glow Plug Controller)

FUEL SUPPLY PUMP (w/ Glow Plug Controller) > INSPECTION

for Preparation Click here



1. INSPECT FUEL SUPPLY PUMP ASSEMBLY
  1. Inspect the suction control valve.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      1.9 to 2.3 Ω

      If the result is not as specified, replace the fuel supply pump assembly.