PCV VALVE > INSTALLATION |
| 1. INSTALL VENTILATION VALVE SUB-ASSEMBLY |
![]() |
Apply adhesive to 2 or 3 threads of the valve.
![]() |
Install the valve.
Connect the ventilation hose to the valve.
Secure the hose with the clamp.
| 2. INSTALL INTAKE AIR SURGE TANK |
![]() |
Install a new gasket and the surge tank with the 2 nuts.
Using an 8 mm hexagon wrench, install the 4 bolts.
![]() |
Install the 3 upper bolts which are used to secure the 2 surge tank stays and throttle body bracket.
![]() |
Install the 3 wire harness clamps and hose clamp.
Connect the throttle position sensor and control motor connector.
Connect the purge VSV connector.
Connect the VSV (for ACIS) connector.
![]() |
Connect the No. 1 ventilation hose.
![]() |
Connect the purge line hose.
![]() |
Connect the No. 4 water by-pass hose.
![]() |
Connect the No. 5 water by-pass hose.
| 3. INSTALL V-BANK COVER |
Install the cover with the 2 nuts.